Qlogic SANbox2-8c Guía de instalación descargar pdf (Pagina 153)

B – Command Line Interface

Reset Command

59042-08 A B-45

services

Resets the switch services configuration to the default values as described in

Table B-15.

snmp

Resets the SNMP configuration settings to the factory default values. Refer to

Table B-13 for SNMP configuration default values.

switch

Resets the switch without a power-on self test. This is the default. This reset

disrupts traffic and does the following:

 Activates the pending firmware.

 Closes all management sessions.

 Clears the event log. To save the event log before resetting, refer to the “Set

Log Command” on page B-71.

To reset the switch with a power-on self test, refer to the “Hardreset Command” on

page B-32. To reset the switch without disrupting traffic, refer to the “Hotreset

Command” on page B-35.

system

Resets the system configuration settings to the factory default values. as

described in Table B-16.

zoning

Clears the zoning database and deactivates the active zone set. The zoning

configuration values (autosave, default visibility) remain unchanged.

Note:  Because this keyword changes network parameters, the

workstation could lose communication with the switch.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 255 256

Sin comentarios

Qlogic SANbox2-8c Guía de instalación Pagina 153