Qlogic Fibre Channel NPIV Storage Networking Guide Especificaciones Pagina 34

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 78
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 33
4-VMM2008 R2 Setup, VM Creation, and NPIV SAN Migration
VM Creation
4-2
Figure 4-1. Hosts Added to VMM2008 R2
In Figure 4-1, the hosts win-3f1kc24knkr.hypernpiv.com and
HostServerA.hypernpiv.com have been added.
VM Creation
This section describes the additional steps needed to create a VM on a Fibre
Channel SAN LUN presented to a virtual adapter port.
Before you can use VMM2008 R2 to transfer virtual machines on a SAN,
automount must be disabled on the Hyper-V hosts that will be either a source or
destination computer for SAN transfers. To disable automount:
1. Open a new command prompt.
2. Type diskpart.
3. At the prompt, type automount disable.
The following message appears:
Automatic mounting of new volumes disabled.
4. Type exit.
Vista de pagina 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 77 78

Comentarios a estos manuales

Sin comentarios