Qlogic SANsurfer FC HBA Manager Guía de usuario descargar pdf (Pagina 160)

10 – Performing Diagnostics

Running Diagnostic Tests

10-8 FS0054603-00 C

10.3

Running Diagnostic Tests

Once you have set the test parameters as described in section 10.2, perform the

following steps to run the loopback or read/write buffer test:

1. Click the Loopback Test or Read/Write Buffer Test button.

2. The diagnostic tests warning displays. Do one of the following:

❑ Click Yes if there are no I/Os active and you want to proceed with the test.

❑ Click No to cancel the diagnostic test.

3. If you selected Yes in step 2, a dialog box displays with the data pattern

generated. Click Stop when you want to end the test.

NOTE: An echo test is run instead of a loopback test under the following

conditions:

■ You have a QLA23xx HBA port that is connected to the fabric through

a point-to-point connection (F-port) or a QLA200 HBA.

■ The HBA is connected to a switch.

■ Your operating system has one of the driver versions listed in

table 10-1.

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 217 218

Sin comentarios

Qlogic SANsurfer FC HBA Manager Guía de usuario Pagina 160