Qlogic QLA2100F Guía de usuario descargar pdf (Pagina 48)

34 Implementing an Open IBM SAN

6. If the file is in the format of filename.tar.Z, type uncompress filename.tar.Z.

7. Type tar xvf lpfc-sparc.tar to “untar” the drive file from the temporary

directory.

8. Type pkgadd -d pwd to install the package.

9. Specify the package number or press Enter to accept all packages.

10.Type y or n to answer the prompt that reads: Rebuild manual pages database

for section 7d [y,n?]:. If you typed y, go to step 11.

11.At the prompt that reads Use IP networking over Fibre Channel [y,n?]: type y

or n. If you typed y, go to step 12.

12.Type the name of the network host name for the adapter.

13.Edit the /etc/hosts file to add the IP address to the host name.

14.At the prompt that reads:

Do you want to continue with the installation of <lpfc>

Ty pe y to proceed with the installation, or type n to undo all the settings and

end the installation.

15.At the prompt that reads:

Select package(s) you wish to process (or ’all’ to process all packages).

(default:all) [?,??,q ]:

Ty pe q.

16.At the system prompt, type shutdown to restart the host system.

17.Login as root.

Note: An installation script displays that prompts you to answer a number of

questions. For each question, enter the appropriate response. Or, press Enter

to each question to accept the default setting.

Note: Rebuilding the manual pages can take up to ten minutes. If you do not

want to build the manual pages, type n.You can run the command later.

Note: The network host name identifies the host adapter on a Fibre Channel

network and is associated with a unique IP address.

Note: If you have more than one adapter in the system, you must create a

hostname.lpfn#file for each adapter.

Note: We recommend that you configure the host adapter parameters before

you shut down and restart the host system.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 405 406

Sin comentarios

Qlogic QLA2100F Guía de usuario Pagina 48