Qlogic QLA2000F Manual de usuario descargar pdf (Pagina 4)

1-2 QLogic QLA2100 Host Bus Adapter Card Installation Guide

6. Insert the

QLogic drivers and firmware update diskette

into the systems diskette

drive.

7. Type

D?QW

as the path to the driver and then click OK.

8. Select QLogic QLA2000/QLA2100 PCI-Fibre Channel Adapter from the list of

drivers and click OK.

9. When the following message appears, click OK to exit the Control Panel:

7KHFKDQJHV\RXKDYHPDGHZ LOOQRWWDNHHIIHFWXQWLOWKH

FRPSXWHULVUHVWDUWHG

10. Click OK to reboot your system.

8SGDWLQJWKH4/RJLF4/$%,26

Your host adapter card is configured with the current version of the basic input-output

system (BIOS). If you need to update the cards BIOS, perform the following steps:

1. Insert the

QLogic drivers and firmware update diskette

into the systems diskette

drive and boot your system.

2. When the

D?

prompt appears, type

FGELRV

and press <Enter>.

3. Type

TO[XWLO

and press <Enter>.

A list appears showing the addresses of the host bus adapters installed in the

system.

4. Type the correct adapter address and press <Enter>.

5. Press <F> and then press <Enter> to flash the BIOS.

When the BIOS upgrade is successfully completed, the following message

appears:

)ODVKSURJUDPPHGVXFFHVVIXO O\

6. Repeat steps 3, 4, and 5 for any other host bus adapters installed in the system.

7. After you finish updating the BIOS for all host bus adapter cards in the system,

you must turn off and then turn on the system for the changes to take effect.

1 2 3 4 5 6 7 8 9 ... 21 22

Sin comentarios

Qlogic QLA2000F Manual de usuario Pagina 4