Qlogic QLA2000F Manual de usuario descargar pdf (Pagina 6)

1-4 QLogic QLA2100 Host Bus Adapter Card Installation Guide

&KDQJLQJWKH195$0IRU8VH:LWKD'HOO3RZHU9DXOW

))RU)5$,'6WRUDJH6\VWHP

If you are using the host adapter card with a JBOD storage system and you need to

connect a RAID storage system to the card, perform the following steps to reconfig-

ure the cards NVRAM settings:

1. Insert the

QLogic drivers and firmware update diskette

into the systems diskette

drive and boot the system.

2. When the

D?

prompt appears, type

FGQYUDP?UDLG

and press <Enter>.

3. Type

TO[XWLO

and press <Enter>.

A list appears showing the addresses of the host bus adapters installed in the

system.

4. Type the correct adapter address and press <Enter>.

5. Press <L> and then press <Enter> to write the NVRAM.

6. Repeat steps 3, 4, and 5 to update the NVRAM of any other host bus adapters

installed in the system.

7. After you finish updating the NVRAM for all host bus adapter cards in the system,

you must turn off and then turn on the system for the changes to take effect.

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Sin comentarios

Qlogic QLA2000F Manual de usuario Pagina 6