Qlogic QLogic Fibre Channel Switch Guía de instalación descargar pdf (Pagina 33)

2 – General Description

Serial Port

59055-00 B 2-9

2.4

Serial Port

The SANbox 5200 switch is equipped with an RS-232 serial port for maintenance

purposes. The serial port location is shown in Figure 2-7. You can manage the

switch through the serial port using the CLI.

Figure 2-7. Serial Port and Pin Identification

The serial port connector requires a null-modem F/F DB9 cable. The pins on the

switch RS-232 connector are shown in Figure 2-7 and identified in Table 2-1.

Refer to ”Connect the Management Workstation to the Switch” on page 4-9 for

information about connecting the management workstation through the serial port.

Table 2-1. Serial Port Pin Identification

Pin Number Description

1 Carrier Detect (DCD)

2 Receive Data (RxD)

3 Transmit Data (TxD)

4 Data Terminal Ready (DTR)

5 Signal Ground (GND)

6 Data Set Ready (DSR)

7 Request to Send (RTS)

8 Clear to Send (CTS)

9 Ring Indicator (RI)

AL A L AL

ALA

Serial Port

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 205 206

Sin comentarios

Qlogic QLogic Fibre Channel Switch Guía de instalación Pagina 33