Qlogic Fibre Channel HBA and VM Guía de usuario descargar pdf (Pagina 14)

Installation

Installing the Hardware

2-2 FC0054606-00 A

Installing the Hardware

Adapter hardware installation requires that you open the computer and locate the

appropriate bus slot for housing the adapter, as detailed in the following steps.

Figure 2-1 shows the hardware placement.

Figure 2-1 Installing the Adapter

To install the adapter:

1. Power off the computer, and then disconnect the power cable.

2. Remove the computer cover and find an appropriate empty bus slot.

3. Pull out the slot cover (if any) by removing the screw or releasing the lever.

4. Grasp the adapter by the top edge and seat it firmly into the appropriate slot.

5. Refasten the adapter's retaining bracket using the existing screw or lever.

6. Close the computer cover.

7. Plug the FC cable into the adapter.

8. Plug in the power cable and turn on the computer.

9. Verify the LEDs on the adapter to ensure proper operation. The LED

patterns are described in “Troubleshooting with LEDs” on page A-1.

ADAPTER

RETAINING

BRACKET

LEVER

SLOT COVERS

SYSTEM

CHASSIS

64-BIT PCI-X SLOT

x4 PCI EXPRESS SLOT

(x8 PHYSICAL SLOT OR

ABOVE REQUIRED FOR

QLE25xx ADAPTERs)

SCREW

ADAPTER

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

Sin comentarios

Qlogic Fibre Channel HBA and VM Guía de usuario Pagina 14