Qlogic QLE2362 Guía de instalación descargar pdf (Pagina 82)

EMC Fibre Channel with Emulex HBAs for the Linux v2.6.x Kernel Environment and the v8.x-Series Driver

Updating the CEE/Menlo Firmware

Updating the QLogic CEE /Menlo firmware for FCoE adapters

FCoE adapters include an additional chip component which requires

the latest supported firmware. This chip is commonly referred to as a

CEE (converged enhanced ethernet) or "Menlo" chip, the purpose of

which is to handle the convergence of storage (FC) and network (IP)

traffic over a single ethernet interface.

To update the CEE/Menlo firmware on the CNAs, follow these steps:

1. Ensure that QLogic SANsurfer and SANsurfer CLI is installed.

Refer to “Upgrading the adapter BIOS” on page 29 for installation

instructions.

2. Copy the appropriate CEE/Menlo firmware file from the

CD-ROM or the EMC-approved section of the QLogic website to

the appropriate directory,

/opt/QLogic_Corporation/SANsurferCLI

3. Execute the command

/opt/QLogic_Corporation/SANsurferCLI/scli.

4. Select options 10 (Utilities), then 6 (FCoE Utility), then 1 (FCoE

Engine), and then 1 (Update Firmware).

5. The utility prompts to enter a file name. Enter the name of the

CEE/Menlo firmware file obtained in Step 2. The utility should

report the update has completed successfully.

6. Press Enter to return to the main menu, then select options 0

(Return to Main Menu), then 15 to exit the SANsurfer CLI utility.

7. Reboot the host for the new CEE/Menlo firmware update to take

effect.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 121 122

Sin comentarios

Qlogic QLE2362 Guía de instalación Pagina 82