Qlogic QLA2342 Guía de usuario descargar pdf (Pagina 36)

EMC Fibre Channel with QLogic Host Bus Adapters in the Solaris Environment

Installing and Configuring the HBA and Driver

• For the QLA2202FS-E:

./qla2x00fcode -l -p

/devices/sbus@1f,0/QLGC,qla@1,3000:devctl -f

2202fs.prom

• For the QLA2342E-SP:

./qla2x00flash -l

/devices/pci@8,700000/fibre-channel@2:devctl

ifp2312.prom

6. Repeat step 5 for other adapters.

7. Reboot the host with the reconfigure option:

reboot -- -r

8. After the system has rebooted, issue the format command to

verify that the device pathname changed to

QLGC,qla when the

FCode was installed.

The display is similar to this:

Using the SANblade Control FX utility

If you are using the SANblade Control FX utility, proceed from step 4

on page 34 as follows:

5. Open the SANblade GUI:

cd /opt/QLogic_Corporation/SANblade_Control_FX

./scfx

Searching for disks... done

AVAILABLE DISK SELECTIONS:

0. c1t0d0 <SUN36G cyl 24620 alt 2 hd 27 sec 107>

/pci@8,600000/SUNW,qlc@4/fp@0,0/ssd@w21000004cf72febf,0

1. c2t1d0 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>

/pci@8,700000/QLGC,qla@1/sd@1,0

2. c2t1d1 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>

/pci@8,700000/QLGC,qla@1/sd@1,1

3. c3t2d0 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>

/pci@8,700000/QLGC,qla@2/sd@2,0

4. c3t2d1 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>

/pci@8,700000/QLGC,qla@2/sd@2,1

5. c4t3d0 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>

/pci@8,600000/QLGC,qla@1/sd@3,0

6. c4t3d1 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>

/pci@8,600000/QLGC,qla@1/sd@3,1

...

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 61 62

Sin comentarios

Qlogic QLA2342 Guía de usuario Pagina 36