Qlogic QLA2342 Guía de usuario descargar pdf (Pagina 51)

Configuring a Symmetrix boot device

Configuring a Boot Device on the EMC Storage Array

c. At the OK> prompt, type setenv auto-boot? true and press

ENTER, so the system will not stop at the OK> prompt after

reset.

d. reset-all

Useful monitor commands

To display various information about the boot HBA:

1. At the OK> system monitor prompt, type select-dev

<controller-path> and press ENTER to select the HBA.

Example: " /pci@1f,4000/QLGC,qla@1" select-dev

2. You can issue any of these commands:

show-boot-id — Prints current boot device ID

version — Prints current version of FCode and firmware

show-connection-mode — Prints current topology

show-adapter-loopid — Prints current adapter-loopId

clear-boot-id — Clears boot-id from the HBA

3. At the OK> prompt, type unselect-dev and press ENTER.

IMPORTANT

If you do not want to boot from this HBA again, you must issue the

clear-boot-id command to remove the boot-id from the HBA.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 61 62

Sin comentarios

Qlogic QLA2342 Guía de usuario Pagina 51