Qlogic QConvergeConsole CLI 8200 Series Guía de usuario descargar pdf (Pagina 105)

5–Fibre Channel Noninteractive Commands

-tb (Target Beacon On/Off)

SN0054667-00 B 5-35

-tb

(Target Beacon On/Off)

To start or stop flashing a target’s LED, issue the following command:

# qaucli -pr fc -tb (<hba instance> | <hba wwpn>) (<target wwpn>)

(<0 | ON> | <1 | PRESET>)

-tp

(Display Host Topology)

Use the -tp option to show the topology configuration of the host:

# qaucli -pr fc -tp | topology

Under Linux, this feature is disabled if you are using the IOCTL or sysfs (inbox)

driver.

-u

(Firmware Area Update/Save)

Use the -u option to update the firmware preload area of the adapter from a

DAT file or to save the current firmware preload area of the adapter to a DAT file.

To update the adapter firmware preload table, enter the following command:

# qaucli -pr fc -u ( <hba instance> | <hba wwpn> ) <file name>

To save the current adapter firmware preload table to a DAT file, enter the

following command:

# qaucli -pr fc -u ( <hba instance> | <hba wwpn> ) save <file name>

Where:

 <hba instance> is the adapter instance number of an adapter port.

 <hba wwpn> is the world wide port name of an adapter port.

 <file name> is the name of the firmware preload table DAT file.

NOTE:

 The <0 | ON> option flashes the LED until interrupted.

The <1 | PRESET> option flashes the LED 12 times.

 This feature is supported only on JBOD (“just a bunch of disks”) devices.

NOTE:

This option is available only for QLE2562.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 299 300

Sin comentarios

Qlogic QConvergeConsole CLI 8200 Series Guía de usuario Pagina 105