Qlogic QConvergeConsole CLI 8200 Series Guía de usuario descargar pdf (Pagina 133)

6–iSCSI Noninteractive Commands

-save (Save Host Configuration)

SN0054667-00 B 6-25

Where:

To continue, press

ENTER

-save

(Save Host Configuration)

To save the configuration (in XML) of all adapters detected, issue the -save

command as follows:

-save <file_name>

-sbootcode

(Set Secondary Boot Target Information)

To set the secondary boot target and LUN, issue the -sbootcode command as

follows:

-sbootcode <hba_port_inst> <Boot Target> <Boot LUN>

Issuing this command saves the configuration data to an XML file portable to all

platforms supported by iSCSI. This command is not active for PPC.

For primary boot code, see “-pbootcode (Set Primary Boot Target Information)” on

page 6-21.

-sbootcodecid

(Set Alternative Client ID)

To set the alternative client ID (seven characters maximum), issue the

-sbootcodecid command as follows:

-sbootcodecid <hba_port_inst> <Alternative Client ID>

This command is not active for the PPC.

–STOP = Stop the test if a failure occurs.

–RWPAT n = Set the pattern to write to the buffer, one of the following:

n = 1 (8 bytes of 0x55h) (default)

n = 2 (8 b.0tes of 0x5Ah)

n = 3 (16 bytes of 0xAAh)

n = 4 (16 bytes of 0xFFh)

hba_port_inst = The adapter port tested.

-CNT = Used with Test Count to set the number of tests, with one test

as default.

Test Count = The number of tests to do, with one as default. Enter a num-

ber between 2–(2

) for more than one test.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 299 300

Sin comentarios

Qlogic QConvergeConsole CLI 8200 Series Guía de usuario Pagina 133