Qlogic SANbox 5600 Series Guía de instalación descargar pdf (Pagina 192)

B – Command Line Interface

Set Config Command

B-70 59096-02 C

zoning

Initiates an editing session in which to change switch zoning attributes. The

system displays each parameter one line at a time and prompts you for a value.

For each parameter, enter a new value or press the Enter key to accept the

current value shown in brackets.

Table B-22. Set Config Zoning Parameters

Parameter Description

InteropAutoSave Available only when the InteropMode parameter is Standard, this

parameter enables (True) or disables (False) the saving of

changes to active zone set in the switch’s permanent memory.

Refer to ”InteropMode” on page B-68. The default is True.

Disabling the Autosave parameter can be useful to prevent the

propagation of zoning information when experimenting with dif-

ferent zoning schemes. However, leaving the Autosave parame-

ter disabled can disrupt device configurations should a switch

have to be reset. For this reason, the Autosave parameter

should be enabled in a production environment.

DefaultVisibility Enables (All) or disables (None) communication among the

switch’s ports/devices and the fabric in the absence of an active

zone set. The default is All.

DiscardInactive Enables (True) or disables (False) the discarding of all inactive

zone sets from that zoning database. Inactive zone sets are all

zone sets except the active zone set. The default is False.

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 279 280

Sin comentarios

Qlogic SANbox 5600 Series Guía de instalación Pagina 192