Qlogic QLA2100F Guía de usuario descargar pdf (Pagina 198)

184 Implementing an Open IBM SAN

Leaving all IP settings as a private network

For using the IN-VSN software from this local private network, the supplied

3Com/US Robotics hub is sufficient enough. To enable all IP based components

to talk together, plug in the Management PC and both INRANGE IP ports to this

3Com Hub. So initially, our network setup looks like that shown in Figure 3-4.

Figure 3-4 Private IP network for initial IN-VSN management ability

Enabling IN-VSN access from a corporate network

To exploit the remote management capabilities of the IN-VSN management

software, we recommend that you connect this network as a subnet to the

corporate LAN.

Before actually changing any parameters, it is important to obtain all the

information you will need in advance, such as:

򐂰 Available IP addresses

򐂰 Valid subnet mask

򐂰 Default gateway

To connect the INRANGE subnet to your corporate LAN, follow these steps:

1. Change the IP setting of the primary FCM blade using the RS232 Interface

(this should be done by INRANGE or IBM Customer Engineers).

2. Change the IP setting of the secondary FCM blade using the RS232 interface

(this should be done by INRANGE or IBM Customer Engineers).

3. Change the IP settings of the management PC using the common Windows

Control Panel tools. Reboot the Windows server.

4. From the management PC, ping both IP addresses of the director to ensure

that everything is set properly (provided that all components are still

connected to the 3Com IP-Hub).

5. Then attach all required ports to a switch or hub that is actually connected to

the corporate network. You could still use the 3Com Hub as a connecting

device.

Ethernet-Hub

Management PC FC/9000

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 405 406

Sin comentarios

Qlogic QLA2100F Guía de usuario Pagina 198