Qlogic QLA4010 Guía de instalación descargar pdf (Pagina 103)

Set the HBA FC-AL Loop ID

2-27

Planning, Miscellaneous Procedures, and Troubleshooting

8. Press ESC to return to the Configuration Settings menu.

9. Press

ESC to return to the Fast!UTIL Options menu.

10. When prompted to save changes made to the current adapter,

select Save Changes and press

ENTER.

11. If there are more adapters to configure, choose Select Host

Adapter, and repeat steps 3 through 11 for each adapter.

12. Press Esc to exit Fast!UTIL.

13. Reboot the host.

14. Repeat this procedure on all nodes in the cluster connected to the

CX200-Series array.

15. While you are in the BIOS, you can verify that the topology is set

correctly for direct connect (FC-AL).

CAUTION

Future use of the firmware NVRAM file to apply settings will

overwrite and possibly invalidate the changes made above. If you

will later update using a firmware NVRAM file, be sure it is listed

and supports this CX200-Series direct-connect cluster

configuration.

To restore EMC default HBA settings, either reload the approved EMC

NVRAM file, or return to step 5 and ensure that Adapter Hard Loop ID is set

to Disabled.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 117 118

Sin comentarios

Qlogic QLA4010 Guía de instalación Pagina 103